Installing The Device In An Equipment Rack With The Rkmt-J15 Bracket; Required Items For The Rkmt-J15 Bracket; Installing The Device With The Rkmt-J15 Bracket - Allied Telesis x320 Series Installation Manual

Installing the Device in an Equipment Rack with the RKMT-J15
Bracket
Required Items
for the RKMT-
J15 Bracket
Installing the
Device with the
RKMT-J15
Bracket
This section contains the procedure for installing the device in a standard
19-inch equipment rack, with the optional RKMT-J15 Bracket.
The following items are required to install the device in an equipment rack
with the RKMT-J15 Bracket:
One RKMT-J15 equipment rack bracket (sold separately)

Four M4x6mm bracket screws (included with the RKMT-J15)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

Note
If the rubber feet have been attached to the device, remove them.
They are attached with double-sided tape.
To install the device in a 19-inch equipment rack with the RKMT-J15
Bracket, perform the following procedure:
1. Have another person hold the RKMT-J15 Bracket at the desired
location in the equipment rack while you secure it using four standard
equipment rack screws (not provided). Refer to Figure 25 on page 63.
x320 Series Installation Guide
62