Choosing A Site For The Device - Allied Telesis x320 Series Installation Manual

Choosing a Site for the Device

Observe these requirements when planning the installation of the switch.
If you plan to install the switch in an equipment rack, check that the

rack is safely secured so that it will not tip over. Devices in a rack
should be installed starting at the bottom, with the heavier devices
near the bottom of the rack.
If you plan to install the switch on a table, check that the table is

level and stable.
The switch can be installed in a standard 19-inch equipment rack,

on a concrete or wooden wall, or on a 35x7mm DIN rail.
The power outlet should be located near the switch and be easily

accessible.
The site should allow for easy access to the ports on the front of

the switch, so that you can easily connect and disconnect cables,
and view the port LEDs.
The site should allow for adequate air flow around the unit and

through the cooling vents on the front and rear panels.
The site should not expose the switch to moisture or water.

The site should be a dust-free environment.

The site should include dedicated power circuits or power

conditioners to supply reliable electrical power to the network
devices.
If you are installing the device in a wiring or utility box, verify that

the enclosure has adequate airflow so that unit does not overheat.
Do not place objects on top of the switch.

The twisted pair cabling should not be exposed to sources of

electrical noise, such as radio transmitters, broadband amplifiers,
power lines, electric motors, and fluorescent lights.
When installing the switch in an indoor or outdoor metal enclosure,

be sure to review the manufacturer's installation guide for rules and
restrictions on site requirements, and to follow all guidelines and
safety warnings.
When installing the switch in an indoor or outdoor metal enclosure,

be sure to properly ground the enclosure to a protective earth
ground following local electrical codes and the instructions in the
manufacturer's installation guide.
x320 Series Installation Guide
40