Eco-Friendly Command - Allied Telesis x320 Series Installation Manual

eco-friendly Command

30
The eco-friendly command is used to toggle the port LEDs on or off. You
can turn off the LEDs to conserve electricity when you are not monitoring
the device. You can toggle the LEDs with the ECOFRIENDLY LED and
NO ECOFRIENDLY LED commands in the Global Configuration mode of
the command line interface of the AlliedWare Plus management software.
The switch is operating in a low power mode when the LEDs are turned
off. Operating the switch in the low power mode does not interfere with the
network operations of the device.
The management software on the switch has a command that blinks the
LEDs so that you can quickly and easily identify a specific unit among the
devices in an equipment rack. It is the FINDME command. The command
works on the switch even if you turned off the LEDs with the eco-friendly
button or NO ECOFRIENDLY LED command.
Note
Before checking or troubleshooting the network connections to the
ports on the switch, you must always check to be sure that the LEDs
are on by issuing the ECOFRIENDLY LED and NO ECOFRIENDLY
LED commands in the Global Configuration mode in the command
line interface.
x320 Series Installation Guide