3.
Open the sample manager door, gently pulling its right-hand edge
toward you.
4.
Press down on the tab to detach the leak sensor connector from the front
of the instrument.
5.
Disconnect the column-outlet PEEK tubing from the detector inlet.
6.
Remove any solvent lines routed behind the column heater door.
7.
Remove the TORX screw from the right-hand side of the column heater,
just behind the eCord receptacle.
Press down on tab to
release connector
Leak sensor
connector
Maintaining the column compartments
TORX screw
eCord
receptacle
115