Oracle SPARC T8-2 Service Manual page 133

Whenever you replace the SPM or the motherboard, update the firmware on the server so
Note -
the portions of firmware in the two components remain consistent.
5. Configure the SPM NET MGT port so that it can access the network, and log in to
the SPM through the NET MGT port.
Refer to Servers Administration or the Oracle ILOM documentation for network configuration
instructions.
Download the system firmware.
6.
Follow the firmware download instructions in Servers Administration or the Oracle ILOM
documentation.
You can load any supported system firmware version, including the firmware version
Note -
that was installed prior to replacing the SPM.
7. If you are replacing an SPM, download the fallback miniroot image for your
hardware and your Oracle Solaris version from My Oracle Support at
support.oracle.com.
Then follow the procedure "Uploading a New Solaris Miniroot Package From SP to Host" in
the Oracle ILOM Administrator's Guide for Configuration and Maintenance.
8. Restore the SPM configuration information you backed up earlier.
At the Oracle ILOM prompt, type:
-> cd /SP/config
-> load -source uritarget
Where acceptable values for uri are: tftp, ftp, sftp, scp, http, https
and target is the location where you stored the configuration information. For example:
-> load -source tftp://129.99.99.99/pathname
9. Set the time and date on the new SPM.
-> set SP/clock datetime
10. If TPM was initialized on the replaced SPM, complete these steps:
a.
Reinitialize TPM and reset the tpmadm failover command if it was previously
in use.
Install the SPM
https://
Servicing the SPM 133