Oracle SPARC T8-2 Service Manual page 101

When adding memory
■
When replacing faulty
■
When replacing a faulty
■
You can perform this procedure, but the server must first be completely powered down and all
power cords unplugged. See
about cold-service procedures.
Whenever you remove a DIMM or a DIMM filler, you should replace it with another
Caution -
DIMM or DIMM filler before powering on the server. Otherwise, the server might overheat due
to improper airflow.
1. Press down both DIMM slot ejector tabs as far as they can go.
2. Carefully lift the DIMM straight up and place it on an antistatic mat.
Related Information
"Install a DIMM" on page 102
■
"Install a Memory Riser" on page 104
■
to the server.
DIMMs.
motherboard.
"Component Service Categories" on page 48
Remove a DIMM
for more information
Servicing Memory Risers and DIMMs 101