Install The Drive Backplane - Oracle SPARC T8-2 Service Manual

Install the Drive Backplane

5. Unplug the two SAS cables, power cables, ribbon cable, and four NVMe drive
cables (if installed) from the drive backplane (panel 1).
6. Push up on the wire tab in the upper corner of the drive backplane (panel 1).
7. Swing the drive backplane back and out of the chassis (panel 2).
8. Install a new drive backplane.
See "Install the Drive Backplane" on page
Related Information
"Install the Drive Backplane" on page 160
■
Install the Drive Backplane
This is a cold-service procedure that must be performed by qualified service personnel. Power
down the server completely before performing this procedure.
160 SPARC T8-2 Server Service Manual • June 2019
160.