Leaving The Mass Spectrometer Ready For Operation - Waters Xevo TQ-S Operator's, Overview And Maintenance Manual
Ivd mass spectrometry system
Hide thumbs
Also See for Xevo TQ-S:
- Operator's, overview and maintenance manual (256 pages) ,
- Operator's, overview and maintenance manual (278 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
3.
Insert a short length (7.5 cm) of PEEK™ tubing, or similar object, into
the reset button aperture to operate the reset button.
4.
Remove the PEEK tubing from the reset button aperture.
5.
Close the mass spectrometer's door.
6.
Wait until the reboot sequence ends before starting the MassLynx
software.
An audible alert sounds when the reboot sequence completes.
Tip:
Leaving the mass spectrometer ready for operation
Leave the mass spectrometer in Operate mode except in the following cases:
•
When performing routine maintenance
•
When changing the source
•
When leaving the mass spectrometer unused for a long period
In these instances, put the mass spectrometer in Standby mode (see the online
Help for details).
2-10
Preparing the Mass Spectrometer for Operation
Reset button aperture
Advertisement
Table of Contents
