8.
Invert the seal breaker and locator tool, and locate it over the end of the
StepWave assembly.
Inverted seal breaker
and locator tool
9.
Push firmly on the seal breaker and locator tool until the tool's face
contacts the adaptor housing.
Rationale:
housing.
10. Remove the seal breaker and locator tool.
Fitting the ion block support to the source
Required materials
•
Chemical-resistant, powder-free gloves
•
3-mm Allen wrench
•
New seals and O-rings
4-70
Maintenance Procedures
This fully locates the StepWave assembly in the adaptor
StepWave assembly
Adaptor housing