Table of Contents
Advertisement
GETTING STARTED
Here are the basic steps to start a safety configuration.
•
•
•
•
•
PRECAUTIONS FOR ENVIRONMENTAL INTERFERENCE
•
•
•
•
•
Package Contents: Check that the Laser Sentinel and all parts supplied with the
equipment are present and intact when opening the packaging (refer to "
).
Contents" on page 3
Read all safety information in
Mechanical Mounting: Laser Sentinel can be installed to operate in different posi-
tions, make sure to follow the exact procedure (refer to
).
Mounting
Electrical Connections: Laser Sentinel must be connected to the application
through the required accessory cables (refer to
Software Configuration: Software configuration of Laser Sentinel can be accom-
plished through the Configuration procedure using the DLSentinel GUI (refer to
Chapter 7, Laser Sentinel Setup and Configuration
The presence of intense electromagnetic interference may affect the correct func-
tioning of the device. This condition shall be carefully evaluated by seeking the
advice of Datalogic Technical Service.
A sudden change in the environment temperature (e.g. with very low minimum
peaks) can generate a small condensation layer on the laser and compromise
proper operation.
The operating distance of the device can be reduced in the presence of smog, fog
or airborne dust.
Installation must be performed by qualified personnel after making sure that the
window is clean and free from scratches, dust, dirt spots and fingerprints. For
more information, refer to
Failure to inspect the window or set the proper environmental condition during
installation may lead to a reduced detection capability of the scanner.
Chapter 3, Safety Information
Chapter 6, Electrical Connections
).
Chapter 10, Device Maintenance
GETTING STARTED
Package
before proceeding.
Chapter 5, Mechanical
).
.
11
INSTRUCTION MANUAL
Advertisement
Table of Contents
