Tightening Torques; Checking, Disassembling And Servicing; Disassembling And Assembling; Separating Rear Axle Case From Brake Case - Kubota MX5100 Workshop Manual

MX5100, WSM

3. CHECKING, DISASSEMBLING AND SERVICING

[1] DISASSEMBLING AND ASSEMBLING

(1) Separating Rear Axle Case from Brake Case

Draining Transmission Fluid
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from oil inlet port after removing the oil inlet (2) up to the
line of the level gauge (3).
• After running the engine for few minutes, stop it and check the oil
level again, add the transmission fluid to prescribed level if its
level is not correct level.
Transmission fluid capacity
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Gauge
(3) Oil Inlet
Rear Wheel
1. Place the disassembling stand under the transmission case.
2. Remove the rear wheel mounting screws and nuts.
3. Remove the rear wheel (1).
(When reassembling)
Rear wheel mounting
Tightening torque
screw and nut
(1) Rear Wheel
ROPS
1. Remove the top link (7), lower link (5) and lift rod (6).
2. Remove the ROPS center (1) and draw out the ROPS upper (2).
3. Remove the ROPS mounting screw and ROPS lower (3), (8).
(When reassembling)
Tightening torque ROPS mounting screw
(1) ROPS Center
(2) ROPS Upper
(3) ROPS Lower R.H.
(4) Fender R.H.
(5) Lower Link
4-S3
REAR AXLE
44.0 L
11.6 U.S.gals
9.7 lmp.gals
(A) Oil level is acceptable within this
range.
W1012439
197 to 226 N·m
20 to 23 kgf·m
145 to 166 lbf·ft
W10110430
166.7 to 196.1 N·m
17 to 20 kgf·m
123 to 144 lbf·ft
(6) Lift Rod
(7) Top Link
(8) ROPS Lower L.H.
(9) Fender L.H.
W10111890