Release Holder And Clutch Lever; Pto Clutch; Removing Pto Clutch Valve - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM

(3) Release Holder and Clutch Lever

[2] PTO CLUTCH

(1) Removing PTO Clutch Valve

Release Holder and Clutch Lever
1. Draw out the clutch release holder (5) and the release bearing
(2) as a unit.
2. Remove the release fork setting screws (1).
3. Draw out the clutch lever (4) to remove the release fork (3).
(When reassembling)
• Make sure the direction of the release fork (3) is correct.
• Inject grease to the release holder (5).
• Apply grease to the bushing and clutch lever.
• After tightening the release fork setting screw to the specified
torque, insert a wire through the hole on the setting screw head
and bind with release fork together.
Tightening torque Release fork setting screw
(1) Setting Screw
(2) Release Bearing
(3) Release Fork
Rear Wheel
1. Place the disassembling stand under the transmission case and
install the front axle rocking resister (refer to the "8. SPECIAL
TOOLS" at "G. GENERAL" section).
2. Remove the rear wheel R.H. (1).
(When reassembling)
Tightening torque Rear wheel mounting nut
(1) Rear Wheel R.H.
2-S10
CLUTCH
167 to 191 N·m
17.0 to 19.5 kgf·m
123 to 141 lbf·ft
(4) Clutch Lever
(5) Release Holder
9Y1210365CLS0011US0
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
9Y1210365CLS0013US0
KiSC issued 07, 2009 A