Error Codes Printed On Reports - Toshiba e-STUDIO170F Owner's Manual

Error Codes Printed on Reports

When an Error Code is printed as a status indication on Transmission Reports, etc., refer to the following description for the applicable Error Code to determine the cause.
Error
Cause
Code
10 Paper Empty
11 Recording Paper Jam
12 Document Paper Jam
13 Cover Open
20 Power Failure
E0 Error relating to the printer or
E6 memory.
STOP
30 was pressed during the
communication.
32 Page # Mismatch
33 Polling Error
How to Correct
Load recording paper and set the
tray.
Open the cover and clear the re-
cording paper jam.
Remove the jammed document.
Close the cover, then retry.
Retry the transmission or ask the
remote party to transmit the docu-
ment again.
Remove the cause of the error on
the printer, if any. Then ask the re-
mote party to retry the transmis-
sion. If not corrected, call your ser-
vice representative.
Retry the transmission or ask the
remote party to transmit the docu-
ment again.
Check the actual document count.
Check polling options setup (securi-
ty code, etc.), and check if the poll-
ing document exists.
Error
Cause
Code
42 Memory Overflow
50 Line Busy
53 Security Mismatch in Relay or
Mail Box transmission
B0-B5 Signal Error or Line Condition Error
C0-C4
D0-D2
F0, F1
87 No residual memory was remain-
ing on the remote party's machine
for Relay or Mailbox transmission.
How to Correct
Wait until the memory is recov-
ered by completing some of the
reserved jobs or remove other
causes if any, then retry the com-
munication.
Send the document again.
Confirm the remote party's securi-
ty code, password, and your set-
up.
Retry the communication. Fre-
quent failures may indicate a
phone line problem. If possible,
move the unit to another line and
try your communications again.
Retry the transmission.
207