Table of Contents
Advertisement
142 Error codes in journal
If "TRANSMISSION ERROR" appears in the display of your fax machine, the error code describes the specific
error. The same code is shown also in the journal and transmission report.
Code
Cause
10
No recording paper
11
Paper jam
12
Documents have jammed in the
document feed.
13
Open the upper covers
20
Power failure
22
Memory error
30
Transmission interrupted by the
transmitter/receiver.
32
Page error
33
Polling error
42
Memory overflow
50
Line busy
53
Wrong codeword
60
Line busy
B0-B5
Communication error
C0-C4
D0-D2
F0, F1
E0-E6
Printer fault
87
Image cannot be saved
How to correct
Put more paper in the paper cassette.
Remove the jammed paper (see
Follow the instructions on
document jam.
Allow these covers to snap carefully into position.
A power failure has occurred.
If this error occurs frequently, please notify the customer
service of your TOSHIBA dealer.
Start the transmission process again or request your fax
partner to repeat the transmission process.
A specific number of pages has been set, but a different
number of pages has been sent (see
Polling was not reserved, or the password was incorrect,
or polling protection did not meet the specified criteria
(see
page
69).
Send your document(s) with a lower resolution, or send
them using the direct mode (see
occurs frequently, please contact your dealer for a
memory extension.
Test the connection using the listening-in option (see
page
48). Have you pressed "*" on the extension for
obtaining an outside line (see
A document has been retrieved with the wrong
codeword (see
page
69).
Send the document again.
Bad line.
The document has probably not been transmitted. You
should transmit your document again to be safe.
A printer error occurred during reception, causing a
memory overflow.
Memory overflow on the other machine. Transmit your
document again later.
page
147).
page 146
to rectify the
page
63).
page
42). If this error
page
18)?
Advertisement
Table of Contents
