Disassembly And Assembly Procedure; Basic Operations - Epson Stylus Pro GS6000 Service Manual

Epson Stylus Pro GS6000

4.4 Disassembly and Assembly Procedure

This section describes procedures for disassembling the components allowed to be
disassembled. Unless otherwise specified, disassembled units or components can be
reassembled by reversing the disassembly procedure.

4.4.1 Basic Operations

4.4.1.1 Unlocking the Carriage
1. Push and open the MAINTENANCE COVER ASSY (right only).
4-26.
2. Insert your hand between the Carriage and the frame as shown in the figure below.
3. Push the lock pin to the rear to unlock the Carriage.
4. Push the Carriage to the center.
Inside
Carriage
Figure 4-11. Unlocking the Carriage
DISASSEMBLY & ASSEMBLY
4.4.1.2 Disposal of Waste Ink
Dispose of waste ink when the ink drain tank is more than half full or when DRAIN
TANK FULL is displayed on the LCD panel.
W A R N I N G
See Figure
1.
2.
3.
C A U T I O N
Push the pin this
way to unlock
the Carriage.
Pin
Insert your
hand into this
space between
Carriage and
the frame.
Disassembly and Assembly Procedure
The waste ink from the printer is industrial waste. It is required to
carry out proper waste ink disposal in compliance with the
industrial waste disposal laws and ordinances of your local
government. Consign disposal of waste inks to an industrial waste
disposer. (At this point, provide the Waste Ink Data Sheet to the
industrial waste disposer, if necessary. You can download it at your
local Epson Web site.)
Prepare an empty container to collect the waste ink.
Lay a protective material on the floor under the ink drain tank.
Open the waste ink valve, and transfer the waste ink to the container.
When transferring the waste ink to the empty container, the waste
ink may splash so put the container close to the waste ink valve.
Container
Figure 4-12. Disposal of Waste Ink (1)
Revision F
Waste ink valve
Confidential
83