Remedies For The Paper Jam Error; Remedies For No Ink Cartridge Error/Ink Cartridge Problem - Epson Stylus PHOTO 890 Service Manual

EPSON Stylus Photo 890/1280/1290

3.1.1.4 Remedies for the Paper Jam Error

This section includes the checkpoints and actions to take to troubleshoot the Paper Jam
error when it occurs during paper feeding or after the printer is turned on.
The printer detects the Paper Jam Error in the following condition.
n
When the printer is turned on, the PE sensor detects paper and attempts to
eject it using the PF roller. But the paper detection signal does no change to
HIGH.
Be sure to follow the steps in the order described in the tables.
NOTE: If the exhibited problem is similar to a problem listed under "Problem", take the
actions in the right column. If not, proceed to the next step.
Table 3-6. Remedies for Paper Jam Error
Step Problem Check & Actions
1 The PF roller turn to eject Explain to the user that a Paper Jam error occurs if the
paper but can not eject it paper whose length is beyond the specifications is
completely. Then a Paper used.
Jam error is displayed.
TROUBLESHOOTING
Table 3-6. Remedies for Paper Jam Error
Step Problem
2 The printer is turned on,
the PF roller turns
continuously for ten
seconds, and then a Paper
Jam error is displayed.
3 ditto
4 Paper is loaded at the ASF
and fed by the PF roller,
but its leading edge dose
not reach the front paper
guide.
The ASF repeats paper
feeding motion and the
Fatal Error is displayed.
3.1.1.5 Remedies for No Ink Cartridge Error/Ink Cartridge
Problem
This section includes the checkpoints and corresponding actions to take to troubleshoot
the No Ink Cartridge Error / Ink Cartridge Problem.
Be sure to follow the steps in the order listed in the table.
Overview
Revision C
Check & Actions
Check if there is any paper debris or dust lodged on the
PE sensor. Also, viewing the PE sensor from the front,
check its lever is set in the correct position.
PE Sensor Lever
Paper Guide Assy.
PF Roller
Referring to Table 3-5 / Step 3, check if the sensor is
operating properly.
Check if the ASF hopper release lever is properly
installed to the LD roller shaft.
Right ASF Hopper Left ASF Hopper
67