Siemens SINUMERIK 840DE sl Commissioning Manual page 555

SD55583 $SCS_TURN_CONT_VARIABLE_DEPTH
= 20
SD55584 $SCS_TURN_CONT_BLANK_OFFSET
= 1
SD55585 $SCS_TURN_CONT_INTERRUPT_TIME
= > 0
= < 0
= 0
Note
The channel-specific cycle setting data SD55585 is only evaluated if
SD55586 $SCS_TURN_CONT_INTER_RETRACTION = 0.
SD55586 $SCS_TURN_CONT_INTER_RETRACTION
= > 0
= 0
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
20% variable cutting depth
1 mm or 1 inch blank allowance
Interruption time in seconds
Interruption time in revolutions
No interruption
Retraction distance at feed interruption
SD55585 $SCS_TURN_CONT_INTERRUPT_TIME has no effect.
No retraction distance
Technologies and cycles
Percentage of the changing cutting depth
when turning a contour
You can select changing the cutting depth
for stock removal and for removing residual
material.
Safety clearance when avoiding obstacles,
to avoid collisions during approach or retrac‐
tion from the machining.
This also applies to stock removal, grooving
and plunge turning.
Time for the feedrate interruption for contour
turning.
This also applies to stock removal, grooving
and plunge turning.
Retraction distance for contour turning
for feedrate interruption.
This also applies to stock removal,
grooving and plunge turning.
21.5 Turning
541