Table of Contents
Advertisement
M3SR Series 4100
Local Voice Forwarding
Due to the fact that voice is routed by means of the waveform settings and IP data should be
used in combination with a broadcast configuration on the waveform layer, voice would be
spread out over all nets which are connected to rebroadcast stations. To avoid this probably
unwanted effect, there is the possibility to disable forwarding of any incoming voice data over
the rebroadcast station. Nonetheless, it is possible to use the local handset or similar equip-
ment to participate in voice traffic of the local waveform net. The feature can be enabled/dis-
abled by R&S RNMS3000 configuration, MMI or remote control (GB2PP).
This functionality has to be set at the receiving-from-air radio. If disabled, all voice
data will be dropped instantly after reception from air. With this feature a rebroadcast
station may be configured to allow bidirectional, unidirectional or no voice forwarding
at all.
5.60
Rebroadcast / Relay Mode
Operating Manual 6175.4760.02 – 01
Advertisement
Table of Contents
