Table of Contents
Advertisement
M3SR Series 4100
1 Network A
2 Network B
3 Network C
4 IDLE
5 BUSY
6 CONNECTED
7 Connecting
8 Rebro-connecting
9 Rebro-busy
10 Connect request
11 Request pending
12 Rebro-busy
13 Remote Network C: State is busy
Network C has an active FLM connection.
Now, an application on PC A2 wants to establish an FLM connection to an application run-
ning on PC C2 and issues a 'Connect Request' (CR) command. The state changes from 'Idle'
to 'Connecting'. The CR is answered by the Radio AtoB in Network A with a 'Request Pend-
ing'. When the 'Request Pending' arrives at radio R2, the state changes to 'Rebro-Connect-
ing' and the 'Relative Idle Timeout' value gets updated. In the meanwhile the forwarded CR
traverses Network B and arrives at the Rebroadcast Radio BtoC. This radio knows the cur-
rent state in Network C and answers the CR with 'Rebro-Busy'. When this messages arrives
at the initiating radio R2 in Network A, the state changes from 'Rebro-Connecting' to 'Rebro-
Busy', followed immediately by a state change to 'Idle'.
Operating Manual 6175.4760.02 – 01
FastLink Mode (FLM)
5.51
Advertisement
Table of Contents
