Selecting The Address For Individual Call - R&S M3SR 4100 Series Operating Manual

M3SR Series 4100
4.3.5.2

Selecting the Address for Individual Call

Softkey
Operating Manual 6175.4760.02 – 01
Type
Listbox
In the central area the currently active value is
displayed.
Selecting the Address for Individual Call
Description
1. Press 'INDV ADDR' softkey.
2. Select desired station name from listbox.
3. Press 'ENT' to confirm the selection.
To initiate an individual call after net Individual
Address was selected, proceed as follows:
If required, terminate an existing link by press-
ing the softkey 'Terminate Link' in ALE OP1 or
2 menu.
Select the scan rate by pressing the 'Mode'
key in ALE OP1 Menu.
Select a message to be sent after link-setup by
pressing 'TX AMD' in ALE OP1 menu, if need-
ed.
Select the TX output power level by pressing
'RF POWER' in ALE OP2 menu.
Press PTT (link mode Analog Voice / FF), ap-
ply data (link mode Internal HF Modem) or
press the 'CALL!' button in ALE OP1 or 2
menu.
4.17