Table of Contents
Advertisement
M3SR Series 4100
4.2 Preparations
The optional communication modes are enabled by means of option keys. A new option key
can be installed in menu Radio MTC 4/7. In menu Radio MTC 4/7 press softkey 'New' and
enter the option key provided by Rohde & Schwarz on demand. For details see
sect. 3.4.9 Menu Radio MTC 4/7 (3004).
All the option keys currently installed on your radio can be seen in the control unit menu Ra-
dio MTC 4/7 in folder 'Valid Option Key' (see Figure 4.1 and sect. 3.4.9 Menu Radio MTC 4/
7 (3004)).
Figure 4.1 Valid Option Keys in Menu Radio MTC 4/7 (Example)
To operate the radio in special communication modes, load a corresponding preset to your
radio. Any communication mode may be assigned to the Preset Pages 1 to 99. For details
about loading of configuration data see sect. 3.8 Radio Configuration with Pre-configured
Parameters.
If for a particular communication mode no option key is installed on your radio, the
radio cannot be operated in this communication mode. When you then try to switch
to a preset page of this communication mode, a message box will come up indicating
a 'Invalid Preset Page'. Please contact your sales representative if you want to order
additional option keys. To order additional option keys for radios that you already
have, you might prepare the form in sect. 9 Drawings. Please note, that SW option
keys are unique for every radio.
4.2
Operation in Special Communication Modes
Operating Manual 6175.4760.02 – 01
Advertisement
Table of Contents
