Table of Contents
Advertisement
M3SR Series 4100
4.3.5.3
Selecting the Address for Net Call
Softkey
4.18
Selection / Editor
Listbox
In the central area the currently active value is
displayed.
Selecting the Address for Net Call
Description
1. Press 'NET ADDR' softkey.
2. Select desired station name from listbox
with the knob.
3. Press 'ENT' to confirm.
To perform a net call carry out the following
steps after the Net Call Address was selected:
If required, terminate an existing link by press-
ing the softkey 'Terminate Link' in ALE OP1 or
2 menu.
Select the scan rate by pressing the 'Mode'
key in ALE OP1 menu.
Select a message to be sent after link-setup by
pressing 'TX AMD' in ALE OP1 menu, if need-
ed.
Select the TX output power level by pressing
'RF POWER' in ALE OP2 menu.
Operating Manual 6175.4760.02 – 01
Advertisement
Table of Contents
