Table of Contents
Advertisement
M3SR Series 4100
The following steps are required to download the configuration:
1. Connect fillgun connector on radio front panel via serial cable to the PC (RS-232-C in-
terface, Figure 3.76).
2. Switch PC and radio on (make sure that the radio is on Preset Page 0).
3. Start the R&S RNMS3000 Mission Planner (MPlan) software on the PC. For further in-
formation refer to R&S RNMS3000 documentation.
4. Create a new mission with the R&S RNMS3000.
5. Generate the radio configurations of the mission with the R&S RNMS 3000.
6. Start the R&S RNMS3000 Remote Device Loader (RDL) software. For further informa-
tion refer to R&S RNMS3000 documentation.
7. In RDL switch to the tab "RS232 M3TR/S4100". All available RS-232-C ports of the PC
are displayed.
8. Select the desired radio configurations in the left window of RDL.
9. Copy the configurations to the desired RS-232-C port using drag and drop.
10. Perform the following actions on a control unit connected to the radio (see
sect. 3.3 Control and Monitoring of Radio and Control Unit) with a session with opera-
tional access rights (see sect. 3.3 Control and Monitoring of Radio and Control Unit).
-
-
-
-
-
-
3.188
From Home menu navigate to fillgun submenu (see sect. 3.3 Control and Monitoring
of Radio and Control Unit)
In the Fill Gun menu press softkey 'RGA'. The radio now searches for available con-
figurations from the PC and displays them in a listbox identified by the Radio Global
Address (RGA).
Select the desired radio configuration to be loaded to the radio with the knob and
press 'ENT'.
Press softkey
to start the download.
The download progress is displayed in the central area of the Fill Gun menu (see
Figure 3.77).
After the download has been finished (100 %) a message box comes up indicating
successful completion.
Download from PC into Radio via Serial Cable
Operating Manual 6175.4760.02 – 01
Advertisement
Table of Contents
