Switching The Controller Reports Position As Controller Feature On Or Off; Table 5.3 Influence Of The Currently Selected Crp Status - R&S M3SR 4100 Series Operating Manual

M3SR Series 4100
5.2.2.11

Switching the Controller Reports Position as Controller Feature On or Off

By means of softkey 'CRP' the operator can enable / disable the controller feature CRP (Con-
troller Reports Position) and permit a controller also to act as provider (see also
sect. 5.2.1.1 Roles of Radios Supporting GPS Reporting).
Softkey
The influence of the currently selected CRP status is summarized in Table 5.3.

Table 5.3 Influence of the Currently Selected CRP Status

Expected Action
Controller responds to immediate
pull request being received from
another controller.
Controller responds to standard
pull request being received from
another controller.
Controller responds to Auto Push
Config Request (APR) being re-
ceived from another controller.
Controller starts to execute RNMS
(Radio Network Management Sys-
tem) based auto push configura-
tion.
Controller transmits its own GPS
(Global Position System) position-
ing information when pulling or con-
figuring other GPS participants.
The terms "at least once" and "never received" refer to the GPS satellite reception after the
preset page supporting GPS reporting has been selected.
Operating Manual 6175.4760.02 – 01
Switching the Controller Reports Position as Controller Feature On or Off
Type
Activate
CRP is off (disabled)
No, controller disregards immedi-
ate pull requests.
No, controller disregards standard
pull requests.
No, controller disregards APR re-
quest.
No, controller disregards RNMS
auto push configuration.
No, controller does not transmit its
own GPS position.
Description
Repetitively pressing this key toggles the fea-
ture on and off.
The new setting is immediately effective.
CRP is on (enabled)
Yes, controller responds immedi-
ately (even if GPS time signal has
not been received yet).
Yes, controller responds using
scheduled transmission (assuming
the GPS time signal has been re-
ceived at least once).
Yes, controller starts to execute
auto push operation using sched-
uled transmission (assuming the
GPS time signal has been received
at least once).
Yes, controller starts to execute
auto push operation using sched-
uled transmission (assuming the
GPS time signal has been received
at least once).
Yes, controller does transmit its
own GPS position (if available).
5.31