Changing The Time Request Interval - R&S M3SR 4100 Series Operating Manual

M3SR Series 4100
4.3.6.22

Changing the Time Request Interval

Softkey
4.58
Type
Editor
In the central area the currently active value is
displayed.
Changing the Time Request Interval
Description
1. Press softkey 'Time REQ INTV'.
2. Enter a new interval or change interval se-
lectively.
3. Press 'ENT' to confirm.
Possible values:
0 minute up to 255 minutes within a stepwidth
of 1 minute
When the time quality of a station falls below a
certain threshold, the time acquisition protocol
is started automatically. Using this protocol the
station tries to improve its time quality. The in-
tervals between these attempts can be pro-
grammed via the function 'Time REQ INTV'.
The protocol runs until the time quality reaches
a sufficient value.
From 0 (off) up to 255 minutes within a step
width of 1 minute.
Operating Manual 6175.4760.02 – 01