M3SR Series 4100
4.4.4.4
Selecting the Call Channel Type
Softkey
Operating Manual 6175.4760.02 – 01
Type
Listbox
Selecting the Call Channel Type
Description
1. Press 'CCT' softkey.
2. Select desired call channel type from list-
box.
3. Press 'ENT' to confirm.
The new call channel type is now selected.
Possible values:
•
next channel
•
best channel
•
fixed channel
Next Channel:
The next link will be set up on the next possible
channel in the scanning cycle. If a link setup
fails, the radio uses a backoff strategy to select
the channel for the next link setup attempt.
With this selection, the link setup is very fast,
but the choice depends on the starting time of
the call, not on the channel quality. Useful
only, if the conditions are very good on all
channels.
Best Channel:
It is recommended to use this call channel type
as often as possible to let the ALE search for
the best available channel.
The next link will be set up on the channel with
the best signal-to-noise ratio (S/N). For this the
radio consults its link quality table.
If a link setup fails, the radio uses a backoff
strategy to select the channel for the next link
setup attempt.
Fixed Channel:
The ALE call will be initiated on an operator-
chosen channel. If a link setup fails, the radio
waits a random time until the fixed channel is
met again. Useful for experienced operators
and known channel conditions.
4.81