Parameter Setting - Mitsubishi Electric MELSEC-L02SCPU User Manual

7.3

Parameter Setting

Set parameters for each axis.
1.
Click the
Project window[Parameter][PLC Parameter]"Built-in I/O Function Setting" tab
2.
Select the "Use positioning function (Axis #1)" checkbox on the top left on the "Positioning Axis
#1 Detailed Setting" window.
3.
Configure required settings.
4.
Click the
Select the "Use positioning
function (Axis #1)" checkbox.
Item
These parameters define data that must be set upon system start-up according to the
Positioning Parameter
drive unit, motor and system configuration used.
OPR Parameter These parameters define data used in OPR control.
Positioning Data A group of data required in a single positioning operation.
When the setting is complete, the necessary external signals are assigned automatically. The drive unit ready signal
and limit signals should be set as necessary. Set the input response time for input signals. The Error time output mode
is fixed to "Clear.
Select an option from the pull-down menu as necessary.
56
button in the "Built-in I/O Function Setting" tab.
button to exit.
Description
According to the settings, external signals are assigned.
Reference
Page 57, Section 7.3.1
Page 64, Section 7.6
Page 91, Section 7.7