Set Up The Bus Labels - Agilent Technologies 16712A Help Manual

See Also "The Sampling Tab" on page 41 for information on setting type and
assigning pods
"Setting the Acquisition Mode" on page 42 for links to this analyzer's
modes
"Performing Clock Setup (State only)" on page 42

Set Up the Bus Labels

The next step is to finish defining the physical connection between the
target system and the analzyer. Use the Format tab to tell the analyzer
what you want to measure on the target system. If you load a
configuration file, this step is taken care of for you.
Group and Label Signals
Because the logic analyzer can capture dozens or even hundreds of
signals, you need to organize the signals by grouping and labeling
channels. Labels are used to group these channels into logical signals;
for example, "addr bus". These groupings are then used in the trigger
tab and the data displays. A label can have up to 32 channels. Each
measurement can define 126 labels. Active channels are indicated like
so
Set Threshold Level
The logic analyzer needs to know what threshold level the target
system is using. You can set the analyzer to use a Standard or a User
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 1: Agilent Technologies 16712A 128K Sample Logic Analyzer
.
Setting Up a Measurement
13