Assigning Pods To The Analyzers; See Also - Agilent Technologies 16712A Help Manual

channel. An active channel looks like
A dash at the top of the activity indicator display indicates that the
signal connected to that channel is electrically high (above the
threshold voltage). A dash at the bottom indicates that the signal is
electrically low. An arrow indicates that the signal is transitioning.
Activity indicators are not affected by label polarity. (see page 66)
You can use these indicators to check whether there is proper probe
connection: bits that are stuck high or low may not be properly
connected. You can also verify that the signals in your target system are
active: bits that are stuck high or low are not crossing the threshold
voltage.
Activity indicators are not displayed during an acquisition.

See Also

"Setting the Pod Threshold" on page 70
Logic Analysis System and Measurement Modules Installation Guide
for details on probing

Assigning Pods to the Analyzers

The Pod Assignment... button under Format can be used to start the
second analyzer on the module and to assign pod pairs.
To Assign Pods to an Analyzer
1. In the Format tab, select the Pod Assignment... button.
2. Drag a pod pair and drop it below the analyzer that you want to assign it to.
3. For pods that you do not want to use, drag and drop them in the
Unassigned Pods area. This preserves memory depth when count is turned
on.
NOTE: When both analyzers are turned on, pods 1/2 and 3/4 of the master card can
not be assigned to the same analyzer.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 1: Agilent Technologies 16712A 128K Sample Logic Analyzer
The Pod Assignment window appears.
Importing Netlist and ASCII Files
.
63