To Reorder Bits In A Label - Agilent Technologies 16712A Help Manual

• waveforms and bus values (where shown) invert in the Waveform Display
tool
• "1" and "0" values flip in the Listing Display tool
Changing the label polarity does not change these things:
• Edge definitions for clock setup and edge terms
• Symbol definitions for the logic analyzer
The default polarity for all labels is positive (+). The various display
tools, in particular the Waveform Display tool, all show logical values
and are affected by polarity changes.
NOTE:
Negative logic is rare in circuits. The main exception at this time is RAMBUS.

To reorder bits in a label

In cases where buses in the device under test haven't been probed with
consecutive logic analyzer channels, you can reorder the bits in a label.
1. In the Format tab, select the label button whose bits you want to reorder.
2. Choose Reorder bits.
3. In the Change Bit Order dialog:
• To reorder the bits individually, enter the bit that the probe channel
• To swap the high and low order bytes or words, select the button Big
• To return to sequentially ordered bits, select the button Default Order
4. Select the OK button.
The label now shows an "R" to indicate that the assigned bit has been
reordered.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 1: Agilent Technologies 16712A 128K Sample Logic Analyzer
should be mapped to.
Endian to Little Endian at the bottom of the dialog.
at the bottom of the dialog.
Importing Netlist and ASCII Files
67