Volume Control; Volume Settings; Code Stops Sound; E / E Keypads Only - Pyronix PCX-256 Programming Manual

5 . 1 3 V o l u m e C o n t r o l
The Volume Control function applies to the loudspeaker output only. Volume levels at the keypad
are programmed individually – please see page: 9.

5.13.1 Volume Settings

Note: 0=Completely Silent, 1=Silent,but sounds a beep when the system is set
The defaults for the volumes of the PCX are as follows:
Entry:
Exit

Alarm

Fire

5.13.2 Code Stops Sound

If this function is enabled (Default), then once an alarm has been generated (even if the code is not
programmed for that partition) the alarm will be silenced, and a 'Misoperation (Abort) signal' will be
sent, but the partition will still be armed until a valid user that controls that partition is entered.

5.13.3 E / E Keypads Only

If there is a speaker connected to the SPK output of the PCX system the entry and exit tones will
be heard through the speaker. If you would like Entry and Exit tones to be heard on only the
keypad and not the speaker then enable this function. (At default this is disabled)

5.13.4 Alert Kps Only

If this function is enabled then any Alert tones will be heard on the Keypad only and not the
speaker. (At default this is enabled).

Volume Control

Using the and
CONTROL? Press the
Partition Volume
Use the numeric keys select the volume level
required for Entry and Exit tones for each
partition, once selected, press the
Repeat for Alarm, Fire, Tamper, Disarmed,
Chime and Intelligent Arm tones. Press
Code Stops Sound
Enter : for No / Enter
Press the key. Repeat for E/E Keypads Only
and Alert Keypads Only. Press the
RINS868-6
4
4
7
7
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e
V O L U M E C O N T R O L
keys, scroll to 'VOLUME
key
key.
: for Yes (Default)
key.
PCX 256 PROGRAMMING MANUAL
Tamper
Disarmed
Chime
Intelligent Arm
key
6
6
3
3
Page: 35