Left Crankcase Cover - Honda XR125LK Owner's Manual

dummyhead dummyhead

LEFT CRANKCASE COVER

REMOVAL
Drain the engine oil (page 3-7).
Remove the following:
– Left side cover (page 2-2)
– Drive sprocket cover (page 2-5)
Disconnect the alternator 2P connector [1] and ignition
pulse generator (Blue/yellow) wire connector [2] from
the connector boot.
Remove the neutral switch wire [1] from the left
crankcase cover ribs [2].
Loosen the left crankcase cover bolts in a crisscross
The left crankcase
pattern in several steps.
cover (stator) is
Remove the bolts [1] and left crankcase cover [2].
magnetically
Remove the dowel pins [3] and gasket [4].
attracted to the
flywheel, be careful
during removal.
INSTALLATION
Clean any gasket material from the mating surfaces of
Be careful not to
the left crankcase and cover.
damage the mating
surfaces.
Install the dowel pins and a new gasket.
Install the left crankcase cover and bolts, and tighten
the bolts in a crisscross pattern in several steps.
Install the following:
– Drive sprocket cover (page 2-5)
– Left side cover (page 2-2)
Fill the crankcase with the recommended engine oil
(page 3-7).
ALTERNATOR/STARTER CLUTCH
[1]/[2]
[1]
[1]
[2]
[2]
[4]
[3]
11-3