Siemens SINUMERIK 840D Programming Manual page 351

5
03.96
04.00
Alarm number
61105
61106
61107
61108
61109
61110
61111
61112
61113
61114
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Alarm text
"Cutter radius too
large"
"Number of or distance
between circular
elements"
"First drilling depth
incorrectly defined"
"No admissible
values for
parameters _RAD1
and _DP1"
"Parameter _CDIR
incorrectly defined"
"Final machining
allowance on the base
> depth infeed"
"Infeed width > tool
diameter"
"Negative tool
radius"
"Parameter _CRAD
for corner radius too
high"
"Machining direction
G41/G42 incorrectly
defined"
Error Messages and Error Handling
5.3 Overview of cycle alarms
Source Explanation, remedy
SLOT1 The diameter of the milling cutter being
SLOT2 used is too large for the figure that is to
POCKET1 be machined; either a tool with a
to smaller radius must be used or the
POCKET4 contour must be changed
LONGHOLE
CYCLE90
HOLES2 Incorrect parameterization of NUM or
LONGHOLE INDA, the circular elements cannot be
SLOT1 arranged in a full circle
SLOT2
CYCLE83 First drilling depth is incompatible with
final drilling depth
POCKET3 Parameters _RAD1 and _DP which
POCKET4 define the path for depth infeed have
been incorrectly set.
POCKET3 The value of the parameter for milling
POCKET4 direction _CDIR has been incorrectly
set and must be altered.
POCKET3 The final machining allowance on the
POCKET4 base has been set to a higher value
than the maximum depth infeed; either
reduce final machining allowance or
increase depth infeed.
CYCLE71 The programmed infeed width is
POCKET3 greater than the diameter of the active
POCKET4 tool and must be reduced.
CYCLE72 The radius of the active tool is negative,
CYCLE76 the setting must be changed to a
CYCLE77 positive value.
CYCLE90
POCKET3 The parameter for corner radius
_CRAD has been set too high and must
be reduced.
CYCLE72 The machining direction of the cutter
radius compensation G41/G42 has
been incorrectly set.
5
5-351