Milling Rectangular Spigots - Cycle76 (Sw 5.3 And Higher) - Siemens SINUMERIK 840D Programming Manual

3
12.97
04.00
3.13 Milling rectangular spigots – CYCLE76 (SW 5.3 and higher)
3.13 Milling rectangular spigots – CYCLE76 (SW 5.3 and higher)
Programming
CYCLE76 (_RTP, _RFP, _SDIS, _DP, _DPR, _LENG, _WID, _CRAD, _PA, _PO, _STA, _MID,
_FAL, _FALD, _FFP1, _FFD, _CDIR, _VARI, _AP1, _AP2)
Parameters
The following input parameters are always required:
real
_RTP
real
_RFP
real
_SDIS
real
_DP
real
_DPR
real
_LENG
real
_WID
real
_CRAD
real
_PA
real
_PO
real
_STA
real
_MID
real
_FAL
real
_FALD
real
_FFP1
real
_FFD
int
_CDIR
int
_VARI
real
_AP1
real
_AP2
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Retraction plane (absolute)
Reference plane (absolute)
Safety distance (to be added to the reference plane, enter without sign)
Depth (absolute)
Depth relative to the reference plane (enter without sign)
Spigot length, for dimensioning from corner with sign
Spigot width, for dimensioning from corner with sign
Spigot corner radius (enter without sign)
Spigot reference point, abscissa (absolute)
Spigot reference point, ordinate (absolute)
Angle between longitudinal axis and 1st axis of plane
Maximum depth infeed (incremental, enter without sign)
Final machining allowance on edge contour (incremental)
Final machining allowance at the base (incremental, enter without sign)
Feedrate on contour
Feedrate for depth infeed
Milling direction: (enter without sign)
Value: 0...Upcut milling
1...Downcut milling
2 with G2 (irrespective of spindle direction)
3...with G3
Type of machining:
Value: 1...Roughing to final machining allowance
2...Finishing (allowance X/Y/Z=0)
Length of blank spigot
Width of blank spigot
3
Milling Cycles
3-189