Definition Files For The Cycles Gud7.Def And Smac.def - Siemens SINUMERIK 840D Programming Manual

1
General
1.7 Cycle startup (SW 6.2 and higher)

1.7.2 Definition files for the cycles GUD7.DEF and SMAC.DEF

Standard cycles need Global User Data definitions (GUDs)
and macro definitions. These are stored in definition files
GUD7.DEF and SMAC.DEF, supplied with the standard
cycles.
In SW 6.3 and higher, these definition files GUD7.DEF and
SMAC.DEF that are used jointly by a number of cycle
packages, will be split. Each package will only have its own
definitions. New cycle files GUD7_xxx.DEF and
SMAC_xxx.DEF will be introduced, that will be in data
management in the definition directory DEF.DIR.
The new files for the standard cycles are:
•
GUD7_SC.DEF and
•
SMAC_SC.DEF.
Startup, upgrades for standard cycles:
•
if a GUD7.DEF is already active in the control, use
"Services", "Data out", "NC active data" to select the
user data of GUD7 and back up the current values in
an archive or onto a diskette;
•
read in files GUD7_SC.DEF and SMAC_SC.DEF from
the diskette and load them to the NCU;
•
read in and activate GUD7.DEF and SMAC.DEF;
•
turn on the NCU;
•
read the archive of saved values back in;
Loading an additional cycle package:
•
unload GUD7.DEF and SMAC.DEF (having backed
up the values if necessary),
•
read in cycles GUD7_xxx.DEF and SMAC_xxx.DEF
of the package and load them to the NCU;
•
reactivate GUD7.DEF and SMAC.DEF.
Handling in the HMI Advanced simulation:
After upgrading the cycle version in the NCU, machine data
adjustment followed by an NC reset of the simulation is
necessary as soon as you start the simulation, in order to
activate the modified definition files.
1-54
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
11.02
© Siemens AG, 2002. All rights reserved