Siemens SINUMERIK 840D Programming Manual page 257

3
12.97
11.02
Note on ShopMill/ShopTurn
In the user cycle Toolcarr.spf,
cycle E_SWIV_H or F_SWIV_H is called under
ShopMill/ShopTurn (see markers _M2 to _M9).
E_SWIV_H parameters (Par 1, Par 2, Par 3)
• Par 1: Number of the swivel data record (_TC1)
• Par 2: Angle of the 1st rotary axis
• Par 3: Angle of the 2nd rotary axis
Modification examples:
If the rotary axes (swivel head/table) are not to be
positioned for swivel data change/tool change, the call
of cycle E_SWIV_H can be commented out at the
relevant markers.
If the rotary axes are to move to a certain position, an
angle value can be transferred in parameters Par 2,
Par 3.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
3
Milling Cycles
3-257