1
General
1.5 Cycle support in program editor (SW 5.1 and higher)
Milling support
The milling support includes the following selection possibilities:
Face
milling
Path
milling
Standard
pockets
Grooves
Spigot
>>
The "Standard pockets", "Grooves"
and "Spigots" soft keys each
branch into submenus offering a
selection of pocket, groove and
spigot milling cycles.
Pocket milling cycles POCKET1 and POCKET2 cannot
be parameterized with this support.
Turning support
The turning support includes the following selection possibilities:
Cut
Thread
Groove
Undercut
The undercut cycles for the E
and F forms (CYCLE94) as well
as for the thread undercuts of
the A to D forms (CYCLE96)
are all stored under the
"Undercut" soft key.
The "Thread" soft key contains a submenu for
selecting between single thread cutting or thread
chaining.
1-46
Thread
milling
Swiveling
cycles
<<
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
09.01
© Siemens AG, 2002. All rights reserved