Cycle Auxiliary Subroutines - Siemens SINUMERIK 840D Programming Manual

1
General
1.2 Overview of cycles
New in SW 5.2 and higher:
Pocket milling with islands
CYCLE73
Transfer of pocket edge contour
CYCLE74
Transfer of isolated contour
CYCLE75
New in SW 5.3 and higher:
Mill a rectangular spigot
CYCLE76
Mill a circular spigot
CYCLE77
Turning cycles
Groove
CYCLE93
Undercut (shape E and F according to DIN)
CYCLE94
Stock removal with relief cut
CYCLE95
Thread undercut (shapes A, B, C and D according to
CYCLE96
DIN)
Thread cutting
CYCLE97
Chaining of threads
CYCLE98
New in SW 5.1 and higher:
CYCLE950 Extended stock removal

1.2.2 Cycle auxiliary subroutines

The following auxiliary routines are part of the cycles
package
• PITCH and
• MESSAGE.
These must always be loaded in the control.
1-20
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
04.00
© Siemens AG, 2002. All rights reserved