Siemens SINUMERIK 840D Programming Manual page 345

4
03.96
04.00
4.10 Extended stock removal cycle – CYCLE950 (SW 5.3 and higher)
Alarm number
61729
61730
61731
61732
61733
61734
61735
61736
61737
61738
61739
61740
61741
61742
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Alarm text
"Internal error: Out of memory
_ALLOC_P_EXTERNAL_ERROR"
"Internal error: Invalid Memory"
"Internal error: Floating-point exception"
"Internal error: Invalid instruction"
"Internal error: Floating_Point_Error"
"Tool point position not compatible with
cutting direction"
"Finished part lies outside blank
contour"
"Tool insert length <
machining depth"
"Machining_Depth_Of_Cut >
Max._Tool_Cutting_Depth"
"Machining_Cutting _Depth <
Min._Tool_Cutting_Depth"
"Incorrect position of tool for this type of
machining"
"Blank must be a closed contour"
"Out of memory"
"Collision during approach, offset not
possible"
Source Explanation, remedy
Check definition of blank contour
Blank contour must be closed, starting
point = end point
4
Turning Cycles
n
4-345