General Information; Troubleshooting In The Cycles - Siemens SINUMERIK 840D Programming Manual

Cycles
Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

5
Error Messages and Error Handling

5.1 General information

5.1

General information

If error conditions are detected in the cycles, an
alarm is output and execution of the cycle is aborted.
The cycles also output messages in the dialog line of
the control. These messages do not interrupt
processing.
For more information on errors and required
responses as well as messages output in the
control's dialog line, please refer to the section for
the relevant cycle.
5.2

Troubleshooting in the cycles

If error conditions are detected in the cycles, an
alarm is output and processing is aborted.
Alarms with numbers between 61000 and 62999 are
output in the cycles. This range is again subdivided
according to alarm responses and acknowledgment
criteria.
The text displayed with the number provides an
explanation of the cause of the error.
Alarm number
61000 ... 61999
62000 ... 62999
5-348
Cancel criterion
NC_RESET
Cancel key
Alarm reaction
Block preprocessing in the NC is aborted
Block preprocessing is interrupted, the
cycle can be continued with NC Start
once the alarm has been canceled
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
5
03.96
© Siemens AG, 2002. All rights reserved

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840diSinumerik 810d

Table of Contents