Siemens SINUMERIK 840D Programming Manual page 32

1
General
1.4 Cycle support in program editor (SW 4.3 and higher)
(I/* 1 2 3 4 11 12 13 14/11/Selecting the
operating mode)[Operating mode / VARI]
In order to achieve compatibility with the states of the
cycle support for interactive programming of the MMC
102/103, only the section in round brackets is
mandatory. The section in square brackets is optional.
Values do not have to be provided for lower/upper limit
and default, see programming example.
Explanation
If the section in square brackets is missing, proceed
as follows:
Short text=
Text in bitmap=
1-32
the first 19 characters of the long text but only up to the first blank from the
right or up to the first comma from the left.
Shortened texts are marked with an asterisk " * "
is read from the Cxx.awb file
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
09.01
© Siemens AG, 2002. All rights reserved