Siemens SINUMERIK 840D Programming Manual page 244

3
Milling Cycles
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
Display options
• $TC_CARR37[n] (n à swivel data record)
If the relevant display options are not set, the value
will not be displayed in the input screen form (see
subsection 3.16.1).
8 7 6 5 4 3 2 1 0
1) Relevant for ShopMill/ShopTurn only.
2) If a swivel data record change has not been agreed, the setting
"Tool change automatic/manual" is not relevant.
3-244
(Tens digits)
0: Axial
1: Axial + angle of projection
2: Axial + angle of projection + solid angle
Rotary axis 1
0: automatic
1: manual
Rotary axis 2
0: automatic
1: manual
Selection axis feed direction
0: no
1: Reference to rotary axis 1
2: Reference to rotary axis 2
Correct tool tip
0: no
1: yes
reserved
Retraction mode
0: Z axis
1: Z axis or ZXY axis
Automatic compensation with Hirth tooth system
0: no
1: 1 rotary axis
st
2: 2 rotary axis
nd
3: 1 and 2 rotary axis
st nd
Swivel data record change / tool change
0: no
1: manual
2: automatic
3: no
4: manual
5: automatic
1)
2)
automatic
automatic
2)
manual
manual
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
11.02
© Siemens AG, 2002. All rights reserved