Siemens SINUMERIK 840D Programming Manual page 47

1
12.97
09.01
Retranslation
The retranslation of program codes serves to change
an existing program with the help of the cycle support.
The cursor is set to the line to be changed and the
"Retranslation" soft key is pressed.
Thus, the corresponding input screen form which
created the program piece is reopened and values may
be modified.
Directly entering modifications in the created DIN code
may result in the fact that retranslation is no longer
possible. Therefore, consistent use of the cycle support
is required and modifications are to be carried out with
the help of retranslation.
Configuring support for user cycles
References: /IAM/, MMC Installation Instructions
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1.5 Cycle support in program editor (SW 5.1 and higher)
BE1 "Expand the Operator Interface"
1
General
1-47