3
Milling Cycles
3.4 Elongated holes on a circle – LONGHOLE
Programming example
Machining elongated holes
With this program you can machine four elongated
holes 30mm in length and with a relative depth of
23mm (difference between the reference plane and
the base of the elongated hole) that lie in a circle
with the center point Z45 Y40 and a radius of 20mm
in the YZ plane. The initial angle is 45 degrees, the
indexing angle is 90 degrees. The maximum infeed
depth is 6mm, the safety distance is 1mm.
N10 G19 G90 S600 M3
T10 D1
M6
N20 G0 Y50 Z25 X5
N30 LONGHOLE (5, 0, 1, , 23, 4, 30, ->
-> 40,
45, 20, 45, 90, 100 ,320, 6)
N40 M30
-> Must be programmed in a single block
3-134
Z
90°
20
40
Specification of technology values
Approach starting position
Cycle call
End of program
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
09.01
Z
A
A - B
45°
Y
X
23
B
© Siemens AG, 2002. All rights reserved