Error Messages - Siemens SINUMERIK 840D Programming Manual

3
Milling Cycles
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)

3.16.6 Error messages

Explanation
Alarm source CYCLE800
Alarm number
61180
61181
61182
61183
61184
61185
61186
61187
61188
62180
62181
Typical display of the swivel angle to be set for a
manual rotary axis in CYCLE800
62180
3-258
Alarm text
"No name assigned to swivel data
record even though machine data
$MN_MM_NUM_TOOL_CARRIER > 1"
"NCK software version too old (no
TOOLCARRIER functionality)"
"Name of swivel data record unknown" See Swivel cycle start-up CYCLE800 à
"Retraction mode GUD7 _TC_FR
outside value range 0..2"
"No solution can be found with current
angle inputs"
"Rotary axis angle ranges incorrect
(min>max) or not defined"
"Invalid rotary axis vectors"
"Block search computation end of block
not valid for SWIVEL"
"No axis name
1st rotary axis declared"
"Set rotary axes x.x [deg]"
"Set rotary axes x.x [deg]"
"Set rotary axes B: 32.5 [deg]"
Explanation, remedy
No name assigned to swivel data record
even though several swivel data records
exist
($MN_MM_NUM_TOOL_CARRIER>0) or
no swivel data record defined
($MN_MM_NUM_TOOL_CARRIER=0)
TOOLCARRIER functionality as from
NCU 6.3xx
Kinematics Name (swivel data record)
See Swivel cycle start-up CYCLE800 à
Retraction;
1st transfer parameter CYCLE800(x,...) is
faulty >2
Check start-up of swivel cycle
CYCLE800
Swivel cycle start-up CYCLE800:
Rotary axis vector V1 or V2 not entered
or incorrect
Select block search with calculation
contour
Swivel cycle start-up CYCLE800: no
entry under rotary axis 1 identifier
Angles to be set for manual rotary axes
Angle to be set for manual rotary axis
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
11.02
© Siemens AG, 2002. All rights reserved