Siemens SINUMERIK 840D Programming Manual page 261

3
12.97
11.02
Calling the "Machining deselection" cycle resets the
changed machine/setting data to the value generated by
the machine manufacturer (machine data settings).
If the machine manufacturer wants an additional
CYCLE832 response that goes beyond the
customization of the technology, the cycle can be
copied to the directory CMA.dir (HMI manufacturer) and
loaded to the NCU. In this case, CYCLE832.spf in
CST.dir (HMI standard cycle directory) must be
unloaded. The machine manufacturer must document
the changes.
Typical CYCLE832 call
T1 D1
G54
M3 S12000
CYCLE832(0.2,1003)
EXTCALL "CAM_Form_Schrupp"
CYCLE832(0.01,102001)
EXTCALL "CAM_Form_Schlicht"
M02
CYCLE832 does not absolve the machine manufacturer
from the requisite optimization tasks when
commissioning the machine. This involves the
optimization of the axes involved in machining and the
settings of the NCU (block search, feedforward control,
jerk limitation, etc.).
Reduced program call
The following call options of CYCLE832 with a
reduced parameter transfer are possible:
• CYCLE832()
• CYCLE832(0.01)
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3.17 High Speed Settings – CYCLE832 (SW 6.3 and higher)
corresponds to the selection of
interactive screen form "Machining" "Deselection"
Entering the tolerance value.
The active G commands are not changed in the cycle.
3
Milling Cycles
3-261