Transfer Island Contour - Cycle75 - Siemens SINUMERIK 840D Programming Manual

3
12.97
08.99
3.15 Pocket milling with islands – CYCLE73, CYCLE74, CYCLE75
3.15.2 Transfer island contour – CYCLE75
Pocket milling with islands is an option and requires
SW 5.2 in both the NCK and MMC 103.
Programming
CYCLE75 (_KNAME, _LSANF, _LSEND)
Parameters
string
_KNAME
string
_LSANF
string
_LSEND
Function
Cycle CYCLE75 transfers island contours to the pocket
milling cycle CYCLE73. The cycle is called once for
each island contour. It need not be called if no island
contours are programmed.
The transferred parameter values are written to the
temporary file opened by CYCLE74.
Description of parameters
The number and meaning of parameters are the
same as for CYCLE74.
(see CYCLE74)
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Name of contour subroutine of island contour
Block number/label identifying start of contour definition
Block number/label identifying end of contour definition
3
Milling Cycles
3-201