Hole Circle - Holes2 - Siemens SINUMERIK 840D Programming Manual

2
03.96
2.3.3 Hole circle – HOLES2
Programming
HOLES2 (CPA, CPO, RAD, STA1, INDA, NUM)
Parameters
real
CPA
real
CPO
real
RAD
real
STA1
real
INDA
int
NUM
Function
A circle of holes can be machined with this cycle.
The machining plane must be defined before the
cycle is called.
The type of hole is determined by the drilling cycle
that has already been called modally.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Center point of circle of holes, abscissa (absolute)
Center point of circle of holes, ordinate (absolute)
Radius of circle of holes (enter without sign)
Initial angle
Value range –180<STA1<=180 degrees
Indexing angle
Number of holes
Drilling Cycles and Drilling Patterns
2.3 Drill pattern cycles
2
2-113