Cycle Support For User Cycles (Sw 6.2 And Higher); Overview Of Important Files; Entry To Cycle Support - Siemens SINUMERIK 840D Programming Manual

1
General

1.6 Cycle support for user cycles (SW 6.2 and higher)

1.6

Cycle support for user cycles (SW 6.2 and higher)

1.6.1 Overview of important files

The following files form the basis for cycle support:
Assignment
Cycle selection
Input screen form for
parameter setting
Help displays
Online Help
(HMI Advanced only)
Any names can be chosen for the cycle support
configuration files (*.com ).

1.6.2 Entry to cycle support

Function
The horizontal soft key HS6 in program editor is
designated the Entry soft key for user cycles. Its
function must be configured in file aeditor.com.
Assign a text to the soft key and configure a function in
the press block for soft key operation.
Example:
//S(Start)
...
HS5=($80270,,se1)
PRESS(HS5)
LS("Turning",,1)
END_PRESS
HS6=("Usercycle",,se1)
1-48
File
aeditor.com
common.com
(HMI Embedded only)
*.com
*.bmp
pgz_<language>.pdf and
pgz_<language>.txt
; HS6 is configured with the "Usercycle" text
Application
Standard and
user cycles
Standard and
user cycles
Standard or user
cycles
Standard or
user cycles
standard cycles only
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
09.01
File type
Text file
Text file
Text file
Bitmap
pdf-file
© Siemens AG, 2002. All rights reserved