Siemens SINUMERIK 840D Programming Manual page 246

3
Milling Cycles
3.16 Swiveling – CYCLE800 (SW 6.2 and higher)
Starting up rotary axis parameters
Input of data relevant to the swivel cycle for rotary
axes 1 and 2.
Name/kinematicsà see CYCLE800 "Kinematics" start-up
menu
Identifiers
$TC_CARR35[n] rotary axis 1
$TC_CARR36[n] rotary axis 2
Axis identifiers of rotary axes. The following identifiers
should be chosen where possible:
Axis rotates about machine axis X --> A
Axis rotates about machine axis Y --> B
Axis rotates about machine axis Z --> C
If the axes of the NCU are known, the same axis identifiers
of the relevant NC rotary axes must be selected (see
automatic mode).
If the axes of the NCU are not known, no known identifiers
can be used.
Mode
$TC_CARR37[n] see display options
• Automatic
NC rotary axes are automatically moved to the
appropriate swivel angle
• Manual
Rotary axes are moved manually by the operator to
the appropriate position. On the "plainest machines"
with manually adjustable rotary axes (measuring
system: Steel gauge), the axis identifier need not be
registered with the NCU.
3-246
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
3
12.97
11.02
© Siemens AG, 2002. All rights reserved